Contact Us

How Do You Use a Foam Engine Degreaser

When the car runs for a period of time, the fuel system will form a certain amount of carbon and deposits, which is inevitable If you want to keep the car engine lasting power, you must use foam engine cleaner.

Under high temperature environment, the emulsified oil thickens seriously like paste, which leads to sludge accumulation over time and becomes gelatinous and hardened after a long period of high temperature.

After the combustion of gasoline will have residual, each engine running for a certain period of time will produce accumulated carbon. Accumulated carbon is black gel, usually located in the intake valves, pistons, spark plugs, exhaust pipes and other parts.

Traffic congestion causing inadequate combustion, adding to poor quality oil, violent driving. Poor gasoline pump conditions and other reasons may accelerate the generation of accumulated carbon.

The internal engine cleaning project is aimed at cleaning the various lubricating oil channels inside the engine, and for carbon, sludge and other impurities inside the engine. The point is that the foam engine degreaser does not damage the seals and gaskets and does not contain harmful solvents.


Foam Engine Degreaser Using Method


What are the specific steps to clean the engine compartment of a vehicle? Firstly we have to prepare: a soft small brush; a few towels (car wash special better); a bucket; several plastic bags or refrigerator cling film (for water isolation); foam cleaner.

Foamy_Engine_Cleaner.jpg

Step 1: 

Park the car at a vent spot in a sunny day. 

Turn off the engine, and turn off all electrical devices in the car. 

Remove the car keys. 

Prepare the pre-work: put on gloves to prevent skin irritation from foam-type cleaners.

If the engine compartment is dusty, wear a mask to prevent dust from drifting into the respiratory tract and also to slow down the pungent smell of the surface plate varnish. 

Prepare a pot of water and soak the towel.

Preparation work is done, and so the engine compartment cooled, you can start to do it.

Step 2: 

Spray foam engine degreaser with a small brush to dust away the dust covering the parts.

If some dust not away, you can use a small air gun or air nozzle, etc. to spray dust (not recommended to use high-pressure water gun).

Clean up after checking whether there is loose circuit joints.

Step 3: 

Start the car, and when wet cloth scrubbing and other foam cleaners are gradually from white foamy into liquid.

This step is also very critical, the humidity of the towel need to be noticed. If the towel is too wet then the drop of water on the engine will quickly evaporate, thus the dirty still exists. If the towel is too dry, it is difficult to wipe up the dirty. You can also use the spray can washing, but also have to do the precautionary measures, which is to use plastic bags or plastic film to isolate electrical equipment.

Step 4: 

Blow dry or wipe dry.

After full cleaning with water, be sure to drain all the water on engine compartment and components.

You can use a cloth with good absorbency to dry the engine compartment parts. It is better not to use a towel, and then leave it to dry completely.


Contact Us